Printer Status Menu; Paper Configuration Settings - Epson StylusPRO 7000 Service Manual

EPSON Stylus Pro 7000

1.6.3 Printer Status Menu

All consumable items and maintenance parts either run out of their contents
or wear out. To determine how much contents (ink) or useful life remains,
compare the message and value shown on the control panel display to the
corresponding value below and the messages in the table below.
E***** F 100~81% full/life remaining
E**** F 80~61% full/life remaining
E*** F 60~41% full/life remaining
E** F 40~21% full/life remaining
E* F 20~1% full/life remaining (generates a warning)
E F Less than 1% full/life remaining (generates an error)
Table 1-35. Printer Status Menu
Display message
VERSION Shows the firmware version.
INK LEFT-K Shows the amount of remaining ink - Black
Shows the amount of remaining ink - Cyan
INK LEFT-C
Shows the amount of remaining ink - Magenta
INK LEFT-M
Shows the amount of remaining ink - Light Cyan
INK LEFT-LC
Shows the amount of remaining ink - Light
INK LEFT-LM
Magenta
Shows the amount of remaining ink - Yellow
INK LEFT-Y
CUTTER LIFE Shows the remaining useful life of the cutter
TOTAL PRINTS Shows the total number of printed documents
Maintenance information
WASTE INK
Maintenance information
CR MOTOR
Maintenance information
PF MOTOR
HEAD UNIT Maintenance information
CLEANER Maintenance information
Product Description
Meaning
SelecType Settings

1.6.4 Paper Configuration Settings

Table 1-36. Paper Config. Menu
Display Message Item
STD
PAPER NUMBER
1~4
THICK. PAT.* Print
PAPER THICK. NO. 1~17
DRYING TIME 0 MIN ~30 MIN
NORM
SUCTION
LOW
Note: The underlined item equals the default.
* The paper thickness detection function is enabled only when PAPER
NUMBER equals something other than standard.
1.6.4.1 Detecting Paper Thickness
This option allows the user to detect the thickness of available paper, and
register up to four user-defined paper types. Ink drying time can also be
registered.
1. Load a sheet of A4 or larger size paper.
2. Press the SelecType button to enter SelecType mode.
3. Select the Paper Config. menu.
4. Select a paper number, one to four. (If you use EPSON media, select STD
and proceed to step 4.)
Revision A
Notes
Select Standard for EPSON special paper.
Select the appropriate number for thick
paper.
Prints a pattern to detect the paper
thickness. If "Paper Number" is set to
"Standard", this message does not
appear.
Select the paper thickness number. If
"Paper Number" is set to "Standard", this
message does not appear.
Determines the length of time the printer
allows the ink to dry. When printing on
roll paper, the printer will wait the
specified time after printing
The vacuum setting.
45