Epson StylusPRO 7000 Service Manual page 38

EPSON Stylus Pro 7000
Table 1-29. Control Panel Messages (continued)
Display Message
When trying to print a test or adjustment
pattern, one of the following occurs:
• Paper not loaded
UNABLE TO PRINT
• Ink cartridge not loaded
• Paper detection error
• The paper was loaded too far foward and
• The paper's horizontal position exceeds the
RELOAD PAPER
• The paper's horizontal position exceeds the
• The cut sheet is too long and cannot be
• Recovery from cutter error.
Loaded paper is too thick to perform timer
REMOVE PAPER
cleaning
Pause state.
PAUSE
• 100ml cartridge
INK LOW
• 200ml cartridge
Printer requires maintenance - see
MAINTENANCE REQ. nnnn
"Maintenance Request" on page 48
PRINTING * Processing print data.
• No paper loaded
• End of roll paper (printer stops feeding)
PAPER OUT
• End of sheet paper (when paper feeds to
Product Description
Meaning
cannot be backward fed to the proper
position.
normal printable area when the paper is
loaded.
normal cuttable area after printing.
ejected properly.
when total dots fired = 90%, cartridge enters
near-end condition. Remaining ink = A1 at
100% duty
when the I/C ink-low flag activates the ink-
low sensor, cartridge enters near-end
condition. Remaining ink = B1 at 100% duty
eject position, put hand under the sheet and
press Cut/Eject to release)
Notes*: If the printer's platen gap setting is set to Thick, a "H" will appear in the
last space on the LCD display.
Control Panel
Revision A
38