Epson StylusPRO 7000 Service Manual page 152

EPSON Stylus Pro 7000
4.2.3.24 Removing the Cover Sensor Assembly
1. Perform the Steps 1 to 13 in "I/C Holder Cover Removal" on page 115.
2. Separate the harnesses for the Cover Sensor Assembly from the six
harness connectors for the Ink Cartridge Sensor and harness bundle for
the Cover Sensor Assembly.
3. Remove the two (CP(W) M2x12) screws securing the Cover Sensor
Assembly and Cover SW Holder, and remove the Cover Sensor
Assembly.
Screws
(M2x12)
Cover SW
Holder
Figure 4-83. Removing the Cover Sensor Assembly
A D J U S T M E N T
Perform the necessary adjustment listed in Table 5-2 in
R E Q U I R E D
Chapter 5. This adjustment is required to make the Cover
Sensor Assembly work interlocking with the close/open status
of the Front Cover.
Disassembly & Assembly
Cover Sensor
Assembly
Disassembly Flow
Revision A
152