Counter Clear; Cleaning Menu - Epson StylusPRO 7000 Service Manual

EPSON Stylus Pro 7000

COUNTER CLEAR

This function resets (to the original condition) the following counters which
are stored in memory on the Main Board.
Table 5-13. Counters Reset by "Counter Clear"
Counter
Protection Counter A/B
Ink Volume Counter Rb/ Ry/ Rx/Rz
Consumed Ink Counter Cb/ Cy/ Cm/ Cc/ Cll/ Clc
Power Cutoff Timer T2
Accumulated Prints Timer
CL Timer
CL Timer 3
CL Flag
Initial Charge Flag
Periodic Pseudo-Vacuum Flag
Note *: "1" means the flag is set, and the next time power is turned on the printer
will perform an initial ink charge.
Before clearing the Waste Ink Counter or the Consumed Ink
C A U T I O N
Counter, make sure you replace the following parts with new
parts.
!
Waste Ink Pads
!
Flush Box
!
Pump Assembly
!
Cap Assembly
!
Head Cleaner
The above parts are provided as [Maintenance Kit, SP-
7000 1054038].
Adjustment

5.4.3 Cleaning Menu

Using this menu you can select a cleaning mode and initiate that cleaning
operation. Also you can select whether or not the printer performs the initial-
cleaning cycle as well as forcefully start the initial-cleaning cycle.
Reset Value
0
0
0
0
0
0
0
0
1*
0
"
Std. KK0 (CL1)
Normal cleaning cycle
"
Std. KK1 (CL1')
Strong cleaning cycle
"
Std. KK2 (CL2)
Strong cleaning cycle
"
Init. Fill
Self-Diagnostic Mode Menus
[Pause] returns you
to previous menu
[SelecType]
Cleaning: Std. KK0
Cleaning: Std. KK1
Cleaning: Std. KK2
Cleaning: Init. Fill
[Item]
Figure 5-39. Cleaning Menu Options
Volume of ink cleared = low
Volume of ink cleared = medium
rubbing = off
Volume of ink cleared = high
rubbing = on
Perform Initial charge sequence
Revision A
[Enter]
Start the
cleaning cycle
187