Epson StylusPRO 7000 Service Manual page 125

EPSON Stylus Pro 7000
4.2.3.1 Replacing the Waste Ink Pads
To keep the printhead clean and maintain quality, the printer drains waste ink
away from the printhead surface and nozzles into the Waste Ink Pads. Once a
predetermined amount of waste ink has been drained, the printer displays the
Disassembly & Assembly
"Maintenance Call 0100" message to indicate the pads are 99% full and then
displays the "Service Call 00000100" message to indicate the pads are
completely full and need to be replaced before printing can continue.
When the waste ink counter indicates the ink pads need to be
C A U T I O N
replaced, the following parts all need to be replaced at the
same time.
!
Waste Ink Pads
!
Pump Assembly
!
Cap Assembly
!
Head Cleaner
!
Flushing Box
C H E C K The above mentioned parts are available as a kit.
P O I N T
Description: MAINTENANCE KIT SP 7000
Parts code: 1054038
1. Remove Paper Guide L2 as described in "Paper Guide L2 Removal" on
page 117.
2. Remove the two waste ink tubes (white, small diameter) and the one
flushing tube (clear, large diameter) from the tubes clamps.
Disassembly Flow
Two waste ink tubes
Figure 4-30. Remove the tubes
Revision A
Flushing
tube
Waste ink
box clamp
125