Installation On An Ethernet Network; Network Setup - Dynamic Ip Address - HMS Netbiter EasyConnect User Manual

Installation on an Ethernet Network

7. Installation on an Ethernet Network
!
Netbiter EasyConnect gateways should only be installed in networks with firewall
protection. Contact your network administrator if in doubt.
In order to connect to Netbiter Argos, Netbiter EasyConnect gateways require outbound
(outgoing) access to the Internet on the TCP ports listed below.
Ports for connecting to Netbiter Argos
Netbiter model
EC310, EC350
EC150, EC220, EC250
Connection attempts will be made to 3 different servers with a timeout of 30 seconds each.
This means that it may take up to 4 min 30 sec to establish a connection for EC150/220/250
(3 ports x 3 servers x 30 seconds).
Other ports
The following ports may also need to be opened in the firewall:
• 502
• 8080

7.1 Network Setup - Dynamic IP Address

When using DHCP (the default setting), there is no need to configure any of the IP address
related settings. The only changes that may be required are the settings needed to pass
through a proxy server on the network, see "Local Proxy Setup" on page 43.
Netbiter EasyConnect Gateway User Manual
TCP ports
443
5222, 443, 80 (the ports are tried in the order shown)
Default port for Modbus TCP
Extra web server
33
Doc: HMSI-168-92 Rev: 3.10