Condition? Command; Figure 5-9 Operation Event Enable Register - Keithley 2016 User Manual

5-58 SCPI Command Reference
Figure 5-9
Operation event
enable register

:CONDition? command

:CONDition?
:STATus:MEASurement:CONDition?
:STATus:QUEStionable:CONDition?
:STATus:OPERation:CONDition?
Description
Bit Position B15 - B11 B10
Event
Idle
1024
Decimal
10
(2 )
Weighting
Value
0/1
Value : 1 = Enable Operation Event
0 = Disable (Mask) Operation Event
These query commands are used to read the contents of the condition
registers. Each set of event registers (except the Standard Event register set)
has a condition register. A condition register is similar to its corresponding
event register, except that it is a real-time register that constantly updates to
reflect the current operating status of the instrument. See [:EVENt] for
register bit descriptions.
After sending one of these commands and addressing the Model 2016 to talk,
a decimal value is sent to the computer. The binary equivalent of this decimal
value indicates which bits in the register are set.
For example, if sending :stat:meas:cond? returns a decimal value of 512
(binary 0000001000000000), bit B9 of the Measurement Condition Register
is set indicating that the trace buffer is full.
B7 B6 B5 B4
B9 B8
Trig Meas
32 16
5
(2 ) (2 )
0/1 0/1
Events : Idle = Idle state of the 2016
Read Measurement Condition Register
Read Questionable Condition Register
Read Operation Condition Register
B3 B2 B1 B0
4
Trig = Triggering
Meas = Measuring Overflow