Figure 4-4 Ieee-488 Connector Location - Keithley 2016 User Manual

To connect the Model 2016 THD Multimeter to the IEEE-488 bus, follow these steps:
1.
Figure 4-4
WARNING: WARNING:
NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY.
NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY.
IEEE-488 connector
HI
location
1000V
TRIGGER
0V
PEAK
!
LINK
AK
500V
PEAK
LO
1 3 5
SENSE INPUT
Ω 4W 2 4 6
!
!
URCE INV/PULSE
42V PEAK
TPUT SOURCE
FUSE LINE
OUTPUT
500 mAT 100 VAC
(SB) 120 VAC
220 VAC
250 mAT
(SB) 240 VAC
CAUTION: CAUTION:
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING. FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING.
2.
3.
4.
NOTE
Line up the cable connector with the connector located on the rear panel. The connector
is designed so that it will fit only one way.
connector.
MADE IN
U.S.A.
(CHANGE IEEE ADDRESS
FROM FRONT PANEL)
RS232
!
VMC
EXT TRIG
LINE RATING
50, 60
25 VA MAX
Tighten the screws securely, making sure not to over tighten them.
Connect any additional connectors from other instruments as required for your
application.
Make certain that the other end of the cable is properly connected to the controller. Most
controllers are equipped with an IEEE-488 style connector, but a few may require a
different type of connecting cable. See your controllers instruction manual for
information about properly connecting to the IEEE-488 bus.
You can only have 15 devices connected to a IEEE-488 bus, including the controller.
The maximum cable length is either 20-meters or 2-meters times the number of
devices; whichever is less. Not observing these limits may cause erratic bus
operation.
Figure 4-4
IEEE-488
120
Remote Operation
shows the location of the IEEE-488
4-9