Power-Up; Line Power Connection; Figure 2-3 Power Module - Keithley 2016 User Manual

2-8 Basic Measurements

Power-up

Line power connection

Follow the procedure below to connect the Model 2016 to line power and turn on the
instrument.
1.
CAUTION
2.
3.
WARNING
4.
Figure 2-3
Power module
Check to see that the line voltage selected on the rear panel (see
for the operating voltage in your area. If not, refer to the next procedure, "Setting line
voltage and replacing fuse."
Operating the instrument on an incorrect line voltage may cause damage to
the instrument, possibly voiding the warranty.
Before plugging in the power cord, make sure that the front panel power switch is in the
off (0) position.
Connect the female end of the supplied power cord to the AC receptacle on the rear
panel. Connect the other end of the power cord to a grounded AC outlet.
The power cord supplied with the Model 2016 contains a separate ground
wire for use with grounded outlets. When proper connections are made,
instrument chassis is connected to power line ground through the ground
wire in the power cord. Failure to use a grounded outlet may result in
personal injury or death due to electric shock.
Turn on the instrument by pressing the front panel power switch to the on (1) position.
Model 2016
WARNING: WARNING:
NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY.
NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY.
HI
1000V
TRIGGER
350V
PEAK
!
PEAK LINK
500V
PEAK
!
LO
1 3 5 VMC
SENSE INPUT
Ω 4W 2 4 6 EXT TRIG
!
!
SOURCE INV/PULSE
42V PEAK
OUTPUT SOURCE
FUSE LINE
OUTPUT LINE RATING
500 mAT 100 VAC 50, 60
(SB) 120 VAC 25 VA MAX
220 VAC
250 mAT
240 VAC
(SB)
CAUTION: CAUTION:
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING.
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING.
MADE IN
U.S.A.
IEEE-488
(CHANGE IEEE ADDRESS
FROM FRONT PANEL)
RS232
120
Line Voltage Selector
Figure 2-3) is correct
Fuse
Spring
Window
Fuse Holder Assembly