Enable Command; Figure 5-6 Operation Event Register - Keithley 2016 User Manual

5-56 SCPI Command Reference
Figure 5-6
Operation event
Bit Position
register
Decimal
Weighting
Value

:ENABle command

:ENABle <Nrf>
:STATus:MEASurement:ENABle <NRf>
:STATus:QUEStionable:ENABle <NRf>
:STATus:OPERation:ENABle <NRf>
Parameters
Query
Description
Operation Event Register:
Bits B0 through B3 — Not used.
Bit B4, Measuring (Meas) — Set bit indicates that the instrument is
performing a measurement.
Bit B5, Triggering (Trig) — Set bit indicates that the instrument is in the
Device Action block of the Trigger Model.
Bits B6 through B9 — Not used.
Bit B10, Idle — Set bit indicates that the instrument is in the idle state.
Bits B11 through B15 — Not used.
B15
B14 - B12
Event
0
Value : 1 = Measurement Event Set
0 = Measurement Event Cleared
<NRf> = 0
1
2
4
16
32
64
:ENABle?
These commands are used to set the contents of the event enable registers
(see Figure 5-7,
with the decimal equivalent of the binary value that determines the desired
state (0 or 1) of each bit in the appropriate register.
B10 B7
B11 B9 B8
Idle
1024
10
(2 )
0/1
Program Measurement Event Enable Register
Program Questionable Event Enable Register
Program Operation Event Enable Register
Clear register <NRf> = 128
Set bit B0
Set bit B1
Set bit B2
Set bit B4
Set bit B5
Set bit B6
Query enable register
Figure 5-8, and Figure 5-9). An :ENABle command is sent
B6 B5 B4 B3 B2 B1
Trig Meas
32 16
5 4
(2 ) (2 )
0/1 0/1
Events : Idle = Idle state of the 2016
Trig = Triggering
Meas = Measuring Overflow
Set bit B7
256 Set bit B8
512 Set bit B9
1024 Set bit B10
16384 Set bit B14
65535 Set all bits
B0