Operating The Projector; Switching The Projector On; Switching The Projector Off - Digital Projection M-Vision Cine 400 3D series User Manual

Digital Projection
M-Vision Cine 400 3D series

Operating the projector

Switching the projector on

1. Connect the power cable between the mains supply and the projector. The projector begins a self-test.
2. When the self-test has completed, the power indicator on the projector control panel shows blue to indicate that the projector is in
STANDBY mode and the lamp is switched off. Press and hold for three seconds either of the following:
● The POWER button on the control panel
● The button on the remote control
ON
The power indicator on the control panel flashes blue for a few seconds whilst the lamp comes up to full brightness. When the projector is
fully switched on and ready for use, the power indicator switches off.

Switching the projector off

1. Press on the control panel or the
POWER
The lamp will switch off, the power indicator on the control panel will start flashing in blue and the projector will be in STANDBY mode
while cooling off.
2. Wait until the power indicator has stopped flashing and the fans have stopped working, then disconnect the power cable.
Revision C, July 2014
OPERATING THE PROJECTOR
button on the remote control, then press the button again to confirm.
POWER
Installation and Quick-Start Guide
Notes
For full details of how to use the
controls and the menu system, see
the Operating Guide.
Even if the power indicator has
stopped flashing, please allow
the lamp to cool off for five
minutes before:
● disconnecting the power
● moving the projector
● changing the lamp
Inst-07