Digital Projection
M-Vision Cine 400 3D series
Control connections
Service port
The service port is used to download firmware updates issued from time to
time by Digital Projection.
LAN and RS232
All of the projector's features can be controlled via a LAN or
serial connection using the text strings described in the Remote
Communications Guide.
Connecting to the projector via a web-based interface is described in the
next chapter, LAN IP configuration utility.
Wired remote control
You can connect a wired remote control to the projector via a 3.5mm jack.
You can also use this socket to connect an external IR repeater if needed.
Trigger 1 and 2 outputs
The Trigger outputs are activated by one of the three following conditions,
as set in the Control menu:
●
Screen trigger: can be connected to an electrically operated screen,
automatically deploying the screen when the projector starts up, and
retracting the screen when the projector shuts down.
●
Aspect ratio trigger: can be used to control screen shuttering for
different aspect ratios.
●
RS232 trigger: can be used to control the screen or screen shuttering
on receipt of an RS232 command.
3D Sync
Connect the Sync Out connector to a Z Screen or 3D IR emitter as
appropriate.
Connect the Sync In connector to a 3D Server as appropriate.
Revision C, July 2014
CONTROL CONNECTIONS
Trigger 1 output
Wired remote
LAN
Trigger 2 output
3D sync
Notes
For a complete listing of pin
configurations for all signal and
control connectors, see Wiring
Details later in this guide.
Plugging in the wired remote
control disables the infrared.
RS232
Service port
Connection Guide
Con-06