Editing Projector Settings; Choosing A Value From A List; Changing The Value Without Viewing The List; Using A Slider To Set A Value - Digital Projection M-Vision Cine 400 3D series User Manual

Digital Projection
M-Vision Cine 400 3D series

Editing projector settings

If the highlighted menu item is a setting with a list of values to choose from,
you can change the value in two different ways.

Choosing a value from a list

To access the list of values and then make a selection:
1. Highlight the menu item and press
2. On the new page that opens, use the
buttons to highlight a value, then press
"check" symbol marks the current selection.
3. Press to exit the list.
MENU

Changing the value without viewing the list

To switch to the next or previous value without viewing the list,
● press the LEFT or RIGHT arrow button.

Using a slider to set a value

Some parameters with a numeric value open a slider. To set such a
parameter:
1. Press the LEFT or RIGHT
The arrow buttons will open the slider and adjust the value at the same
time. / will open the slider without altering the initial
ENTER SELECT
value.
2. Use the LEFT and RIGHT
3. When ready, press MENU to exit the slider.
Revision C, July 2014
/ .
ENTER SELECT
UP and DOWN arrow
ENTER / SELECT again. A green
arrow button, or ENTER / SELECT .
arrow buttons to move the slider.
USING THE MENUS
MENU >>
Selected Item <Value>
Item <Current Value>
Item <Value>
Item <Value>
<Highlighted Value>
Unavailable Item
Unavailable Item
Item
Item
List of values
Parameter
Slider
Operating Guide
Notes
Some menu items may be
unavailable due to settings in
other menus. Unavailable menu
items appear gray.
101
Op-04