Table of Contents
Advertisement
Mode) that change the operation of the unit. Loop operation is only available when the mode is
selected.
0= Mode
Select Auto, Rehearse, Manual, Review Mode by depressing Mode key.
Leave Mode by depressing illuminated Mode key
Whilst mode is active the Locate command will locate pre-roll before record in. Record On and Record
off commands are global, the record advance may be changed by entering required record advance
followed by Store followed by Record.
1= Cmd
Perform an auto edit, rehearse, review, manual by depressing the selected command key. The system
will locate record in and perform edit/rehearse. Whist active the selected command LED will be
illuminated, Once finished the LED will extinguish. Record On and Off commands are performed
individually by each serial port, the record advance for each machine may be individually adjusted using
Root | Iface | Record | Menu 40:- Record Advance.
2= Editor
This is the same as 1= Cmd except that, all group enabled machines are selected and the system then
performs an auto edit/Review. Once the edit is finished the machines are released and become
individual again.
7.88 At end of Auto-Record
MENU 88:- At end of Auto-Record:-
0= Redo 1= Stop 2= In 3=Review 4= Play
When the auto record out is activated this parameter selects what the system will do next.
7.89 ADR Backup Machine
MENU 89:- ADR Backup Machine
0= NONE, 1= A 2= B 3= C 4= D (5=E)
When either Auto-Record or Manual-Record mode are enabled a DAT machine may be used as a
backup recorder on the specified serial port.
Note: Once a backup dat machine is enabled an extra delay of 70 frames is added to allow for the
lockup and PNO record of the DAT. If the pre-roll is to short the system will not go into record even if
locked.
7.90 Constant Offset Mode
MENU 90:- Constant Offset Mode
0= On 1= Off
The Record In, and Offset are interactive, by changing one then the others will change. This parameter
determines how they interact.
Using the Equation Master Position - Master Offset = Slave Position - Slave Offset the following
calculations will be made after each type of user entry.
Constant Offset
Changing the controlled machine's record in/out points will change machine in/out points in order to
maintain a constant offset.
CB ELECTRONICS LTD
Advertisement
Table of Contents
