Table of Contents
Advertisement
MENU 35:- Rmt FWD/RWD Cmds to Video Mcn
0= Normal, 1= Convert to Shuttle
Use if Remote Fwd/Rwd commands cause video to lose picture.
7.36 Enable Auto-In when NOT Play
MENU 36:- Enable Auto-in When NOT Play
0= No, 1= Yes
When enabled all record enabled channels will switch to input monitor when not in Play (assuming
machine accepts command).
Note. On the Doremi V1 this command illuminates the Record Tally.
7.37 Setup Access
MENU 37:- Setup Access
0= Setup, 1= Shift,Setup, 2= Password
This menu controls access to the Setup Menu
0= Setup
Depress [Setup]
1= Shift,Setup
Depress [Shift] followed by [Setup]
Password software not currently Installed
2= Password
Enter the user defined password 00:00:**:** then Depress [Shift] followed by
[Setup]
To define your password enter 29:06:**:** followed by [Shift] followed by [Store] followed by [Setup].
Then save your password using:
Setup | Unit | Generic | Menu 30:- Macro Protection 4= Wr Usr.
If you forget the password or someone has changed your password, enter a new password. If you do
not wish to use a password the we suggest that you set the password to 00:00 in case anyone enables
the password.
7.38 Jog Response
MENU 38:- Jog Response
0= 1= 2= 3= 4= 5= 6= 7= 8= 9=
Increasing the number will increase the speed of the machine relative to the speed with which the jog
wheel is turned.
7.39 Jog Wheel
MENU 39:- Jog Wheel
0= On Cmd 1= Always, 2= TestK, TestC
0= On Cmd
CB ELECTRONICS LTD
UNIT JOG
Advertisement
Table of Contents
