Iface Select Menu; Record Tracks; Analogue And Video Record Ready; Record Tally Source - CB ELECTRONICS SR-3 User Manual

The Jog or Shuttle key have to be depressed before the jog wheel may be used.
1= Always
The Jog wheel is always active, the mode when turned is the same as the last mode selected by the
jog or shuttle keys.
2= TestK
Used to check both the keyboard and jog wheel, when active the keyboard entry display will show the
number of the last key depressed. The jog wheel is shown as three key depressions as follows:-
00:3A:NN:SS
Where 3A = Jog Wheel, NN = Direction and number of pulses, SS= Speed
The jog wheel will send 3A:00:00 when stopped.
3= TestC
The IFACE Menu is applied to each serial port separately, first select the serial port you wish to use,
then enable setup.
7.41 Interface Parameter
MENU 41:- IFACE: Select Menu
0= Record, 1= Chase, 2= General, 3= Type

7.42 Record Tracks

MENU 42:- Record Tracks
0=Off 1=Alg 2=8 3=16 4=24 5=32 6=40 7=48
The record command sent to the machine depends on the number of digital channels as follows:-
0= Off
No Track arm commands sent to machine, track arm on the machine or machine remote.
1=Alg
Analogue 1-4, Video, and Assemble only
2=8
Analogue 1-4, Video, Assemble and up to 8 Digital Record channels.

7.43 Analogue and Video Record Ready

MENU 43:- Analogue and Video Rec Rdy
0= Disable 1= A1-A2 2= A1-A2+V 3=Asmb
To enable crash record or insert edit on the Timecode or Cue tracks (A3 & A4) select 3=Asmb.

7.44 Record Tally Source

MENU 44:- Record Tally
0= REC or EDIT, 1= Record, 2= Edit
Some non-edit machines give a permanent Edit tally (for example the VO9600), if this is the case select
the appropriate tally source to disable.

7.45 Record Command Type

CB ELECTRONICS LTD
IFACE MENU
IFACE RECORD