Table Of Contents - CB ELECTRONICS SR-3 User Manual

0.00 QUICK START, HOWTO & UPDATES
0.01 ONE FINGER TYPIST, STICKY KEYS
0.02 INSTALLING NEW SOFTWARE
0.03 RECORD ENABLE
0.04 KEY A ON THE SR-3
0.05 MASTER CHASE
0.06 MACHINE REFERENCE: VIDEO SYNCS or WORD-CLOCK
0.07 USING THE GENERATOR AS A MASTER
0.08 CRASH RECORD
0.09 USING THE SR-3 WITH A DAW
0.10 CONVERTING SR-4 -> SR-3
0.11 Setting the Pre-Roll, Start Time, Loop Delay, Post-Roll, Record Advance and End Time
1.0 Multi Machine Synchronizer Set Up
1.01 The SR-4 as a multi-machine synchroniser
1.02 SR-4 BLOCK / SR-3 BLOCK
1.03 SR-4 Timecode Output
1.04 SR-4 Timecode Input
1.10 Setting up the System
1.11 Defining the Master
1.12 SR/MR Timecode Generator Output
1.13 Defining a Machine as a Slave
1.14 Displaying the Chase Group
1.15 Entering a Offset
1.16 Trimming a Offset
1.17 Entering a Negative Offset
1.18 Pre-Roll
1.19 Post-Roll
1.20 Delay
2.0 DISPLAY
2.01 STATUS INDICATOR
2.02 MACHINE NAME
2.03 POSITION
2.04 CURRENT ENTRY
2.05 PREVIOUS ENTRY
2.06 MESSAGE TO USER
2.07 RECORD BANK
2.08 SR24 KEYBOARD DISPLAY
2.09 ERROR MESSAGES
3.0 KEYBOARD
3.01 SHIFT
3.02 STORE / RECALL / TRIM - / TRIM +
3.03 TRIM + / TRIM -
3.04 RECALL-RECALL
3.05 LOCATE
3.06 INSTANT REPLAY
3.07 AGAIN
3.08 MARK
3.09 CHASE GROUP SELECTION
3.10 RECORD ENABLE
3.11 MASTER MACHINE
3.12 CHASE (SLAVE) MACHINE
3.13 RECORD TRACK ENABLES
3.14 RECORD BANK
3.16 RM-6/Video Slave [CMD] (originally [Number])
3.17 RM-6/Video Slave [Offset]
CB Electronics
Contents
SR/MR User Manual 29 April 2004 SR-User 5