Table of Contents
Advertisement
1) Auto-Record Drop in / Drop out enabled.
2) At post roll past the Record Out point the system will either stop or locate pre-roll before record
in (See Unit Set-up).
On selecting the AUTO REC mode the following commands are sent:-
1) Locate pre-roll ahead of Record-in.
4.04 MANUAL RECORD
SHIFT followed by AUTO-RECORD will enter Manual Record, the AUTO-RECORD LED will flash. The
system will loop between REC-IN and REC-OUT as normal but will not enter record or drop out of
record.
In the Manual Record mode the following apply:-
1 )
N o
A u t o - R e c o r d
2) If Enabled A record off command will be sent at the Record Out point, At post roll past the
Record Out point the system will either stop or locate pre-roll before record in (See Unit Set-up).
On selecting the MAN REC mode the following commands are sent:-
1) Locate pre-roll ahead of Record-in.
4.05 REVIEW
MODE
SHIFT followed by REHEARSE will enter Review, the REVIEW LED will Flash. The system will loop
between REC-IN and REC-OUT as normal but the will not enter record automatically or manually.
In the Review mode the following apply:-
1) Both Record and Un-Record are disabled.
On selecting the Review mode the following commands are sent:-
1) Locate pre-roll ahead of Record-in.
4.06 NEXT LOOP
4.07 PREV LOOP
System/Machine
1) Auto/Rehearse/Manual/Review
Active or Setup Mode
2) Dat Machine
3) Slow-Motion Active
5) MR System
4.08 JUMP TO LOOP ???
To access a specific loop, enter the loop number and use either Store or Recall followed by Next
Loop or Prev Loop. Note that this will access the loop at this pointer location, where extra loops have
been inserted or the loops are not numerically labelled then some intuitive guesswork may be needed.
4.09 JOIN LOOP
(Available as Macro Key)
Used to Join two or more loops each depression of this key increments the loop pointer and updates
the Record Out only. The Record In is left at the original value.
4.10 INSERT LOOP
Used to insert a new loop in an existing list, the same loop number is used with a letter suffix e.g. 11 -
> 11A, 11A -> 11B....
4.11 DELETE LOOP
CB ELECTRONICS LTD
MODE
O n
c o m m a n d
(Available as Macro Key) or [ID <<]
(Available as Macro Key) or [ID <<]
4) Doremi V-1
(Only available with Next Loop Macro Key)
(Available as Macro Key)
(Available as Macro Key)
i s
s e n t
[ID <<]
Prev Loop
Locate Prev ID
Decrease Speed
Increase Speed
Prev Segment
Decrease Giant
Display
Brightness
a t
t h e
I n
P o i n t
[ID >>]
Next Loop
Locate next ID
Next Segment
Increase Giant
Display
Brightness
Advertisement
Table of Contents
