Table of Contents
Advertisement
Auto Record and ADR(TAKER) are linked, they use the same Record-In and Out keys, Auto and
Rehearse keys. Root | Auto/ADR | Options |Menu 77: Auto-Rec, Rehearse allows the user to select
between Adr Mode, Cmd, and Editor Modes as follows:-
1= Cmd , 2= Editor
These are used for video editing and assembly where compensation is required for different machines
record in delays. The Auto and Rehearse keys have the following functions when 1=Cmd or 2= Editor
are selected
Auto Key
Locate to Pre-Roll before the specified record in point and commence auto edit. If the system is
currently in record/rehearse it will be necessary to hit the auto key twice as the record exit routine
will clear any auto edit.
Rehearse Key
Locate to Pre-Roll before the specified record in point and commence auto rehearse (All channels
in record Ready will switch to input between the record in and out points). If the system is currently
in record/rehearse it will be necessary to hit the rehearse key twice as the record exit routine will
clear any auto edit.
0=ADR Mode
In ADR/Taker applications where there is one record machine and the operator controls the record
advance to compensate for both the Machine and the Talent. This mode also allows the Out point to
be turned off using the Cycle/Out Enable Macro Key.
0= ADR Mode
There are 4 LOOP modes:-[Auto], [Rehearse], [Manual], and [Review] as described below, the
loop modes are selected, enabled and disabled using these keys. When any loop mode is active
the system is modified as follows:-
1) The Locate switch is modified to always locate pre-roll ahead of Record-In.
2) Shift followed by Locate locates Record-In.
3) Auto will locate to preroll before record in, when all machines arrive the system will start the auto
record.
1= Cmd / 2= Editor
The [Auto] and [Rehearse] keys act as commands, when initiated the system will locate to pre-roll
before the Record-In point and wait for all machines to arrive. The system will then enter Play
followed by Record or rehearse at the in-point. Once the system leaves record or play the
Auto/Rehearse LED will extinguish and the system will revert to normal.
4.01 AUTO and REHEARSE OFF
When no LOOP mode is active the following applies:-
1)
LOOP keys are NOT active.
2)
The LOCATE key locates Current Entry display with/without pre-roll as determined by menu
28.
4)
SHIFT-LOCATE locates the Current Entry display with/without pre-roll as determined by menu
28.
4.02 REHEARSE
In the rehearse mode the following apply:-
1) Both Record and Un-Record are disabled.
2) At post roll past the Record Out point the system will locate pre-roll before Record In.
On selecting the Rehearse mode the following commands are sent:-
1) Locate pre-roll ahead of Record-in.
4,03 AUTO RECORD
In the Auto Record mode the following apply:-
CB ELECTRONICS LTD
4.00 AUTO RECORD/ADR/TAKER MODES
MODE
MODE
Advertisement
Table of Contents
