Command Enable; Auto Unlace Enable; Colour Framing - CB ELECTRONICS SR-3 User Manual

7.73 Command Enable

MENU 73:- Command Enable
0= All 1= Status Request 2= Cmd 3= None
0= All
All commands from SR Remote are sent to the controlled machine.
1= Status Request
Status and Position Requests only are sent to the controlled machine
2= Cmd
Commands only, no status is requested from device.
3= None
No commands or data requests are sent to the controlled machine
7.74 Auto Unlace
MENU 74:- Auto Unlace
0= Enabled, 1= Disabled
This parameter allows you to disable the auto-ulace and rely on the machines unlace function.

7.75 Colour Framing

MENU 75:- Colour Framing
0= Off, 1= 4 Field, 2= 8 Field
This Parameter determines the colour framing of the machine when in Play and a Slave. At all other
times the Colour framing is determined by the machine Setting (switch or menu).
The normal setting for audio applications is 0= Off. Any other setting can cause sync problems.
7.76 R3422 : Timecode Offset
Some Machines can have an offset between the RS422 and Timecode when in play, this parameter
allows you to specify a correction factor to adjust for this.
Note: The correction factor is not used when the machine is not playing.
To check the correct value for this parameter
1) Select Root | 0=Unit | 2= Code | Menu 25: Slave Tally Source 2= Error. This will enable the error
display in frames and 1/10's in the centre of the upper line.
2) Connect the timecode output from the machine to the timecode input on the timecode and GPI
In/Out on the SR/MR controller.
3) Select the machine port required, if using a MR system and the selected machine is connected to
an MR-3 select the machine as a Master for better positional information.
4) Play the machine and check the error. Changing this parameter will directly adjust the error displayed
CB ELECTRONICS LTD
MENU 76:- RS422 : Timecode Offset
0= -2frm 1= -1frm 2= 0frm 3=1frm 4= 2frm