Table of Contents
Advertisement
3.01 SHIFT
When the shift led is illuminated the function of some keys is modified as follows:-
0 / Clear
Locate
Shift
>>
<<
MCN-1..MCN-4
Reader
Chase/Offset
Stop
Play
3.02 STORE / RECALL / TRIM + / TRIM -
When the STORE, RECALL or TRIM LED's are illuminated the keyboard stores may be accessed. Note
that the STORE, RECALL and TRIM functions are self-cancelling and will cancel after about 5 seconds
if no second key is depressed. The keyboard stores are as follows:-
Record-In
Record-Out
0-9
Shift 0-9
Record
Stop
<<
>>
Instant Replay
Locate
Next Loop
Chase/Offset
< Reverse Play
> Play
The Store key is used as follows:-
1)
2)
3)
e.g.
The lower Right display should say:-
The RECALL key is used as follows:-
1) Hit the RECALL key and illuminate RECALL
2) While the RECALL LED is illuminated hit any of the keys listed above to display the contents of the
keyboard store.
e.g. To Recall the RECORD IN point the following key sequence should be used:-
[Recall] [Record In]
The lower Right display should say:-
CB ELECTRONICS LTD
3.00 KEYBOARD
Clear keyboard buffer.
Locate without pre-roll.
Delete last numeric key entry
Unlaced Forward Wind
Unlaced Reverse Wind
Select the master machine
Select the timecode reader as a timecode only master
Slave Machine: calculate the offset between master and slave at current
position and enable chase.
Master Machine: Deselect all slaves and reset all offsets.
Unlace machine
Send PLAY command to machine without checking if a RECORD OFF
command should be sent instead
Record in point
Record Out point
Scratch pad stores
More Scratch pad stores
Record Advance
Loop Delay
Head of tape
End of tape
Instant Replay
Recall Last locate point
Use Store to jump to specified loop Number
Store/Recall the current machine Offset.
Pre-Roll
Post-Roll
Use the MARK key to capture a timecode number on the fly or use the numeric
keypad to enter a timecode number.
Hit the STORE key and illuminate STORE
While the STORE LED is illuminated hit any of the keys as listed above to save
the data.
To enter a value of 01:00:00:00 as the RECORD-IN point the following key
sequence should be used:-
[1] [0] [0] [0] [0] [0] [0] [Store] [In]
Rec In 01:00:00:00
Rec In 01:00:00:00
Advertisement
Table of Contents
