Setup; Root: Select Set-Up Required - CB ELECTRONICS SR-3 User Manual

At first the set-up on the SR/MR may appear very daunting, but if you can set-up your mobile phone
then this should be simple! When you connect the system it should work from first connection. The unit
setup is preset for normal operation, and machine setup is automatic provided that the machine is
identified correctly.
Once the machine is identified correctly the machine interface software (IFACE) parameters will be set
up automatically, after this the user may modify the setup if required, The modified setup will remain
until Hard reset or a different machine is connected to the port.
Machines such as the DA88, DA98, and DD8 have setup options for machine ID and record track
arming. These must be set correctly in order that the interface identifies the machine correctly and sets
up the track arming correctly. For further information on machines check the SR-Tech manual.
The software in the MR/SR and in different machines changes, because of this the user can access
all the parameters used in the system. If you need to change an individual parameter to suit your
software please inform us so that we can keep both our manual and software up to date. The current
manuals are available from our web site www.colinbroad.com, the current software for standard
products is also available on our web site.
After switching on the unit entering setup will access the Root Menu, at other times entering setup will
access the last menu displayed.
To leave the setup menu use the [Setup] key from the Root Menu, if not in the Root Menu, the first
depression of the [Setup] key will return to the Root Menu, a second depression of the [Setup] key
will exit Setup.
The set-up menu map (SR-Menu) is split into four diagrams. The first shows an overall picture the next
three expand individual sections. From the Root Menu you can access any menu. If you are in setup
and not in the ROOT Menu then depressing the [Setup] key will take you there.
Whilst the set-up mode is active the Set-up LED will be illuminated. Once within the set-up menu the
key functions are modified as follows:-
[0]-[9] Select next menu or the setting within the current menu.
Store Save the current setting and select Next menu
Recall Save the current setting and select Previous menu
Set-up If the ROOT MENU is displayed then exit Set-up if any other menu is displayed then
Goto the ROOT MENU.
The Sr/MR Setup is split into three sections as described in section 7.01 below.

7.01 ROOT: Select Set-up Required

MENU 01:- ROOT: Select Setup Required
0= Unit, 1= Auto/ADR 2= IFace
0= Unit Select unit setup menu, global parameters that determine system operation and
are not machine specific.
1= Auto/ADR Auto Record/ADR Loop entry and Option selection
2= IFACE The currently selected Serial port protocol and its connected machine control
parameters, once setup is entered it is not possible to change the selected port.
Currently two of the unit parameters determine the default setup of the machine interface ports as
follows:
Setup|UNIT|MENU 14:- Default Alg & Vid Rec Rdy
Setup|UNIT|MENU 16:- Default Chase Type
These two parameters are used to determine the default machine interface parameters when a new
machine is connected to a port.
CB ELECTRONICS LTD
7.00 Set-up