Table of Contents
Advertisement
7.30 Macro Protection
MENU 30:- Macro Protection
0=Off 1= On, 2= Rd Usr 3= Rd Fac 4= Wr Usr
This menu provides two functions
1) Enable and disable changes to the keyboard, Macro keys, pre-roll ...
2) Control access to the EEPROM and FACTORY setups
The addition of an EEPROM to the system allows the user to select between three different settings
as follows:
1) Current: destroyed when Read User or Read Factory are selected or a Hard Reset command.
2) User: selected by Read User or a hard reset command
3) Factory: selected by Read Factory
This Menu controls access to user settings and the EEPROM
0= Off
Macro's can be changed from the keyboard.
System Track Arm Keys may be changed from the keyboard
Pre/Post Roll May be changed from the keyboard
1= On
Macro's cannot be changed from the keyboard
System Track Arm Keys cannot be changed from the keyboard
Pre/Post Roll cannot be changed from the keyboard
2= Rd Usr
On exit from Setup the unit will read User Setup from EEPROM, the macro protection will default to 1=
On. This is activated on leaving setup.
3= Rd Factory
On exit from Setup the unit will read the Read Factory Setup from EPROM, the macro protection will
default to 1= On. This is activated on leaving setup.
4= Wr Usr
Setup the unit to work in your preferred manner then select to write current setup to EEPROM, the
macro protection will default to 1= On. This is activated on leaving setup and may take up to 20
seconds to compleat the write.
The following table shows how the memory's are initialised after a power-up reset or a hard reset.
Action
Power-On or
Reset Button
Hard Reset
7.301 Installing New Software
When new software is installed it may be necessary to initialise user setup in the EEPROM as follows:-
i)
Select the Macro protection Menu Setup | Root | Unit | Generic: menu 30:- Macro Protection
ii)
Depress the 3 key to select 3= Rd Fac.
iii)
Depress the Setup key twice to exit setup.
iv)
Depress the Setup key to Re-enter the macro protection menu, this should now be selected to
CB ELECTRONICS LTD
UNIT GENERIC
Unit
Macro's
Setup
Battery backed RAM
EEprom (User)
System
Machine
Track Map
Parameters
Eprom
Temp
Stores
Cleared
Advertisement
Table of Contents
