Mixed Code & Offset; Mixed Code Passing Through Zero/Midnight; Offset And Record In - CB ELECTRONICS SR-3 User Manual

6.111 Mixed Code & Offset
There will nearly always be an offset due to the fact that there are a different number of frames in
each minute. The normal starting point is 01:00:00:00, at this point there is an offset of 108 frames
or 3 seconds and 18 frames.

6.112 Mixed Code Passing through Zero/Midnight.

If there are a different number of frames in each minute then it follows that there are a different
number of frames in each day. This causes a problem when passing through midnight as at this
point the frame count is reset to zero changing any current offset.
To overcome this problem add an identical time to both the master and slave offsets. This will
change both the master and slave's effective positions and remove the problem.

6.20 Offset and Record In

Offset and Record In interact, the relationship between machines may be defined as offset or sync
points. When defining the record in point on a machine you are also defining the sync point. The
following three Setup Variables effect the action when a new record in point is defined.
Setup | Root | Unit | Record | Menu 05:- Master/Rec Enab Offset Change
When disabled setting the record in point on a record enabled machine will set the master record
in point and not change the offset.
Setup | Root | Unit | Record | Menu 12:- Constant Offset Mode
If constant offset mode is ON then the offset will always remain constant and the in points will.
change.
Setup | Root | Auto | Options | Menu 77:- Auto-Rec, rehearse
When set to Editor setting the master record in point will zero the master offset.
Effect of Changing the Record In point
Selected Effect On
Machine Master
Master Set Rec In
Slave Mcn Update Rec In
Free Mcn
Effect of Changing the Record In point
Selected Effect On
Machine Master
Master Set Rec In
Slave Mcn Update Rec In
Free Mcn Update Rec In
CB ELECTRONICS LTD
Constant Offset= 1= Off
Effect On
Slave Mcn
Update Rec In
Set Rec In
Constant Offset= 0= On
Effect On
Slave Mcn
Update Rec In
Set Rec In
Update Rec In
Effect On
Free Mcn
Update Offset
Update Offset
Set Rec In
Update Offset
Effect On
Free Mcn
Update Rec In
Update Rec In
Set Rec In