ISHIDA BC-4000 Service Manual page 18

2.2.1.3 B01-01-03 Label Width
Operation
1. Press the [ ] or [ENTER] key to enter B01-01-03 menu.
or
2. Measure the label width.
3. Key in the numeric value (0.1mm units), and press the [ENTER] key.
2.2.1.4 B01-01-04 Label Sensor Distance
Operation
1. Press the [ ] or [ENTER] key to enter B01-01-04 menu.
or
2. Key in the label sensor distance (between the label sensor and the thermal head), and press the
[ENTER] key.
Note: Normally, this value is fixed at 73.0mm.
2.2.1.5 B01-01-05 Label Type Selection
Operation
1. Press the [ ] or [ENTER] key to enter B01-01-05 menu.
or
2. Key in the label type number (0: Die-cut labels (standard) or 1: Continuous labels) and press the
[ENTER] key.
or
BC-4000 Service Manual No. 085-6693-02
WIDTH (30.0 to 200.0mm)
b01-01-03 WIDTH
SENSOR DISTANCE (0.1mm)
b01-01-04 DISTANCE
DIE-CUT=0, CONTINUOU=1
b01-01-05 CONTINUOUS
Chapter 2 SETUP MODE
0.0
73.0
0
2-3