Table of Contents
Advertisement
4.1.9
Configuring Tel to IP Routing Table
The Tel to IP Routing Table is used (as an alternative to a Proxy server) to route outgoing
Tel-to-IP calls to a remote IP destination, or to the MediaPack itself (depending on the
extension number). The Tel to IP Routing Table is used as an alternative to a Proxy server.
The procedure below describes how to configure Tel-to-IP call routing according to our
example setup: Outgoing Tel calls with numbers 2000 and 4000 are to be routed to IP
address 10.33.2.36; while outgoing Tel calls with numbers 1000 and 3000 are to be routed
back to the MediaPack itself.
To configure the Tel to IP Routing table:
1.
Open the 'Tel to IP Routing Table' screen (Protocol Management menu > Routing
Tables submenu > Tel to IP Routing option).
2.
Add the four entries displayed in the figure above by performing the following:
a.
From the 'Position' drop-down list, select the entry that you want to add.
b.
In the 'Destination Number' field, enter the extension number you need to reach.
c.
In the 'Destination IP' field, enter the destination IP address.
d.
Click the Insert button to add the entry.
For detailed information on the Tel to IP Routing table, refer to Section
Table' on page 106.
User's Manual
Figure 4-15: Tel to IP Routing Table Screen
60
MediaPack BRI Series
'Tel to IP Routing
Document #: LTRT-83702
Advertisement
Table of Contents
