Table of Contents
Advertisement
3.
From the 'ISDN Ports' drop-down list, select the ISDN port that you want to configure.
4.
From the 'Uni-side' drop-down list, select the type of ISDN port:
•
User: User side is used when the MediaPack's port is connected to a network
side entity such as an ISDN line or a PBX network interface.
•
Net: Network side is used when the MediaPack provides the network side
interface and the port is connected to a terminal equipment such as an ISDN
phone or PBX.
(In our example setup for Unit A, ISDN Port 1 is configured as User and ISDN Port 0
is configured as Net.)
5.
From the 'ISDN Interface' drop-down list, select the ISDN interface number to which
the port belongs. Each ISDN port must bind/map to an ISDN interface. The mapping is
important because the IP to Tel Routing table routes the IP call to a designated ISDN
interface. The call is then established on the ISDN port that corresponds to the
specific ISDN Interface configured in this step.
(In our example setup for Unit A, ISDN Port 0 is bind to Interface 0 and ISDN Port 1 is
bind to Interface 1.)
6.
Click the Submit button, and then perform steps 3 through 5 for each ISDN port.
For additional information on configuring ISDN ports, refer to Section
94.
User's Manual
Figure 4-8: ISDN Ports Screen
52
MediaPack BRI Series
'ISDN
Port' on page
Document #: LTRT-83702
Advertisement
Table of Contents
