Table of Contents
Advertisement
User's Manual
In case of a ping request failure, verify the PC's IP configuration is correct and that the
network cables are connected properly. If a failure continues, use the MediaPack's
'Reset' button at any time to restore the MediaPack networking parameters to their
factory default values (refer to
Figure 4-2: Connecting MediaPack to PC for Initial Configuration
4.1.2
Configuring the MediaPack's LAN and WAN IP Addresses
The MediaPack is supplied with default networking parameters (show in the table below)
and with an application software residing on its flash memory (with factory default
parameters).
The MediaPack's default LAN IP address is used to initially access the device.
To assign an IP address to the MediaPack you can use one of the following methods:
HTTP using a Web browser (refer to
Embedded command line interface (CLI) accessible via Telnet or serial connection
(refer to Section
DHCP (refer to Section 'Services' on page 137).
Network Interface
LAN
WAN
If these default addresses correspond with those of your network, skip to Section
'Connecting the MediaPack to the
procedure to change the addresses and network masks.
Version 2.2
'Assigning an IP Address using
Table 4-1: MediaPack Default Networking Parameters
IP Address
192.168.2.1
Assigned by DHCP
'Restoring Factory Default
'Assigning an IP Address Using
CLI' on page 45).
Network' on page 50. Otherwise, refer to the following
41
4. Initial Configuration
Configuration' on page 152).
HTTP' below).
Subnet Mask Address
255.255.255.0
Assigned by DHCP
July 2007
Advertisement
Table of Contents
