Table of Contents
Advertisement
User's Manual
To configure QoS:
1.
Open the 'QoS Profiles' screen (Advanced Configuration menu > Network Settings
> QoS Source Classes option).
2.
In the Rate Limit Setting of the WAN Interface group, define the rate limit of the WAN
link in the 'Rate Limit' field.
3.
Select a traffic class (e.g., local-default) that you want to configure, by selecting the
radio button corresponding to the class.
4.
Configure the QoS profile according to
5.
Click the Modify button.
6.
To save the changes to the flash memory, refer to Section
Settings on the
Parameter
Rate Limit
[rate-limit <num>]
For each of the four available traffic Classes, specify the following parameters:
Name
Version 2.2
Figure 6-23: QoS Source Classes Screen
MediaPack' on page 146.
Table 6-21: QoS Parameters Description
Description
Specifies the available upstream bandwidth. This parameter is required for the
scheduler to operate correctly.
Specifies the name of the service class to be configured.
There are 3 built in service classes
Local-voice: Locally generated RTP packets
Local-default: All other locally generated traffic
Default: Routed packets
A fourth class "user-defined" is provided.
The Access control list can be used to override local provided defaults (listed
above or to assign the "user-defined" source class
Table
6-21.
127
6. Configuring the MediaPack
'Saving Configuration
July 2007
Advertisement
Table of Contents
