Table of Contents
Advertisement
♦
♦
User's Manual
e.
Exit the WAN mode using the following command:
192.168.2.1(if-ip)[WAN]# exit <CR>
f.
Continue to Step 6 to configure the default gateway IP address
DHCP:
a.
Ensure that you have a DHCP server in your WAN network.
b.
Enable the new configuration by typing the following command:
192.168.2.1(IF-IP)[WAN]# shutdown <CR>
192.168.2.1(IF-IP)[WAN]# no shutdown <CR>
c.
Verify the new WAN IP settings by typing the following command:
192.168.2.1(IF-IP)[WAN]# show ip interface WAN <CR>
d.
Continue to Step 7 to save the configuration.
e.
Exit the WAN mode using the following command:
192.168.2.1(if-ip)[WAN]# exit <CR>
PPPoE:
a.
Ensure that you have a PPPoE server in your WAN network.
b.
Change the interface mode to PPPoE using the following command:
192.168.2.1<if-ip>[WAN]#ipmode PPPoE <CR>
c.
Configure the PPPoE settings by typing the following command:
192.168.2.1(if-ip)[WAN]#pppoe user <username> secret
<password> authmode <chap|pap> <CR>
48
MediaPack BRI Series
Document #: LTRT-83702
Advertisement
Table of Contents
