Table of Contents
Advertisement
4.
In the 'SIP Proxy & Registration' screen, perform the following:
a.
When working with a Proxy server, set the 'Enable Proxy' field to 'Enable', and
then in the 'Primary Proxy' field, enter the IP address of the primary Proxy server.
When no Proxy is used, the Internal Routing table is used to route the calls (refer
to sections
page 108).
(In our example setup for Unit A, 'Enable Proxy' is set to 'Enable' and 'Primary
Proxy' is defined as 10.33.2.20.)
b.
In the 'SIP Domain Name' field, enter the SIP domain name. (In our example
setup for unit A, the SIP domain name is defined as 10.33.2.35).
c.
From the 'Enable Registration' drop-down list, select one of the following for
proxy registration:
♦
♦
(In our example setup for Unit A, 'Enable Registration' is set to 'Enable'.)
User's Manual
Figure 4-11: SIP Proxy & Registration Screen
'Tel to IP Routing
'Disable': the MediaPack doesn't register to a Proxy server/Registrar
(default).
'Enable': the MediaPack registers to a Proxy server/Registrar at power up
and every 'Registration Expiry Time' seconds; The MediaPack sends a
REGISTER request according to the 'Authentication Mode' parameter.
Table' on page
106
and
56
MediaPack BRI Series
'IP to Tel Routing
Table' on
Document #: LTRT-83702
Advertisement
Table of Contents
