Table of Contents
Advertisement
A.1.2
Using Point-to-Point Connections, PBX Trunk Interface
A Point-to-Point connection between the PBX and the MediaPack is illustrated in the
network architecture diagram below
PBX's Trunk interface. In other words, the MediaPack provides an ISDN Network and the
PBX is a User/Terminal device.
Figure A-2: Connecting to a PBX using Point-to-Point Connection, PBX Trunk Interface
To configure the MediaPack connection to the PBX:
1.
Perform the initial configuration of the MediaPack's IP interfaces and network settings
(refer to Section
2.
Access the 'ISDN Ports' screen (Protocol Management menu > ISDN submenu >
ISDN Port Settings option).
User's Manual
(Figure
'Connecting MediaPack's LAN Interface to your
158
MediaPack BRI Series
A-2). The MediaPack is connected to the
PC' on page 40).
Document #: LTRT-83702
Advertisement
Table of Contents
