Table of Contents
Advertisement
User's Manual
To configure the MediaPack connection to the PBX:
1.
Perform the initial configuration of the MediaPack's IP interfaces and network settings
(refer to Section
2.
Access the 'ISDN Ports' screen (Protocol Management menu > ISDN submenu >
ISDN Port Settings option).
3.
From the 'ISDN Ports' list, select an ISDN port.
4.
From the 'Uni-Side' drop-down list, select 'Net'.
5.
From the 'Layer 2 Mode' drop-down list, select 'Point to Multipoint'.
6.
From the 'ISDN Interface' drop-down list, select the ISDN interface to which the
configured port binds.
7.
Click Submit to apply your changes.
8.
To save the changes to the flash memory, refer to Section
Settings on the
9.
Return to the initial settings and continue from the ISDN Interfaces configuration (refer
to Section
Note:
A.2
Lifeline and Fallback Setup
For Lifeline and Fallback setup, refer to Section
and Section
Version 2.2
'Connecting MediaPack's LAN Interface to your
Figure A-5: ISDN Ports Screen
MediaPack' on page 146.
'Configuring the ISDN
Regarding the ISDN interface configuration, in the example configuration of
the PBX connection (Point to Multipoint, Net interface), the MSN
configuration is not applicable (for additional information on MSN refer to
Section 'MSN' on page 172.
'Connecting the PSTN Fallback
Interfaces' on page 53).
'Connecting the Lifeline
Port' on page
36
163
A. MediaPack Applications
PC' on page 40).
'Saving Configuration
Port' on page
respectively.
July 2007
34
Advertisement
Table of Contents
