Table of Contents
Advertisement
4.1.7
Configuring Coder Groups
The procedure below describes how to define coder groups in the 'Coder Groups' screen.
In our example setup for Unit A, no configuration changes were made in this screen.
To configure the coder groups:
1.
In the 'Quick Setup' screen, click the Coder Groups arrow button or navigate to the
'Coder Groups' screen (Protocol Management menu > Profile Definitions submenu
> Coder Group Profiles option).
2.
From the list of coder groups, select the coder group, and then define up to five
coders.
Note:
User's Manual
Figure 4-13: Coder Groups Screen
The preferred coder is the coder that the MediaPack uses as a first choice
for all connections. If the far-end gateway does not use this coder, the
MediaPack negotiates with the far-end gateway to select a coder that both
sides can use.
58
MediaPack BRI Series
Document #: LTRT-83702
Advertisement
Table of Contents
