Bang & Olufsen BeoVision 7 Reference Book page 43

Re-scan TV channels
You can add new channels or update scanned
channels which, for example, have been
moved by the broadcaster.
> Press TV to switch on the television.
> Press MENU to bring up the TV SETUP menu
and press to highlight CHANNEL SETUP.
> Press GO to bring up the CHANNEL SETUP
menu and press to highlight RF.
> Press GO to bring up the RF menu.
> Press to select the source of your TV video
signals – CABLE, CABLE BOX, ANTENNA or
OFF– and press GO to store it.
> If you select CABLE or ANTENNA, scanning
begins automatically. New channels are added
automatically as they are found.
Note: If you re-scan all your TV channels, all
channel settings you have made disappear!
RF
SOURCE CABLE
store
If you only wish to check for a new signal on a
scanned channel that has been empty, do not re-
scan all TV channels. Instead, select the channel in
the channel list using the number buttons on
Beo4. For further information about the channel
list, refer to the chapter 'Watch TV' on page 6 in
the Guide.
If you select CABLE BOX or OFF in the RF menu,
the EDIT CHANNELS and FINE TUNE menus are
inaccessible.
GO
43