Static/Default Route Settings - D-Link xStack DES-3800 Series User Manual

Static/Default Route Settings

Entries into the Switch's forwarding table can
be made using both MAC addresses and IP
addresses. Static IP forwarding is accomplished
by the entry of an IP address into the Switch's
Static IP Routing Table. To view the following
window, click L3 Features > Static/Default
Route Settings.
This window shows the following values:
Parameter Description
IP Address The IP address of the Static/Default Route.
Subnet Mask The corresponding Subnet Mask of the IP address entered into the table.
Gateway The corresponding Gateway of the IP address entered into the table.
Metric Represents the metric value of the IP interface entered into the table. This field may read a
number between 1-65535 for an OSPF setting, and 1-16 for a RIP setting.
Protocol Represents the protocol used for the Routing Table entry of the IP interface. This field may read
OSPF, RIP, Static or Local.
Backup State Represents the Backup state that this IP interface is configured for. This field may read Primary
or Backup.
Delete
Click the
To enter an IP Interface into the Switch's Static/Default Route Settings window, click the Add button, revealing the following
window to configure.
The following fields can be set:
Parameter Description
IP Address Allows the entry of an IP address that will be a static entry into the Switch's Routing Table.
Subnet Mask Allows the entry of a subnet mask corresponding to the IP address above.
Gateway IP Allows the entry of an IP address of a gateway for the IP address above.
Metric (1-65535) Allows the entry of a routing protocol metric representing the number of routers between the
Switch and the IP address above.
Backup State The user may choose between Primary and Backup. If the Primary Static/Default Route fails,
the Backup Route will support the entry. Please take note that the Primary and Backup entries
cannot have the same Gateway.
Click Apply to implement changes made.
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
to delete this entry from the Static/Default Route Settings table.
Figure 8- 8. Static/Default Route Settings – Add window
Figure 8- 7. Static/Default Route Settings window
110