Yaesu WIRES-X HRI-200 Instruction Manual page 83

● Sound settings
This menu appears only during an analog operation.
Connect response
Select the response sound when accepting a connection request or connecting to another node or room.
ID
Select the ID audio format transmitted periodically.
<Universal>
• OFF ..........................................Does not output sound.
• WAVE FILE ...............................Plays the specified audio file (wav file).
• CW ...........................................Transmits the specified text content in mores code signals.
• VOICE ......................................Transmits sound played using VOICE.
[Test] ...........................................Click to transmit an audio test message according to your setting.
[Stop] ..........................................Click to cancel the test transmission.
WIRES-X Software
Select this to make [...] on the right selectable. Click this to display the file selection screen
where you can select your desired WAV file.
Enter a response sentence or the ID in the text box. The following symbols and characters can
be used.
Symbols (" $ ' ( ) + , - . / : = ? @), space, numbers (0 to 9), alphabetic characters (A to Z and a
to z)
Caution Only qualified users are permitted to transmit CW data.
For example, if your station is JQ1YBG, messages shown below will be played.
• While initiating a connection or connecting from your node
"This is JQ1YBG WIRES-X. Connected to *****." (***** refers to the connection destination
ID)
• When connecting to your station from another node
"This is JQ1YBG WIRES-X. Connected from *****." (***** refers to the connection destination
ID)
• When there is no connection
"This is JQ1YBG WIRES-X. Not connected."
Caution While connecting to another node or room, test transmission does not function.
Main Menu
83