Yaesu WIRES-X HRI-200 Instruction Manual page 24

Operation mode
Select one of the following (4) WIRES-X modes in accordance with your transceiver configuration.
Tip The default setting is Analog.
• Digital .......................................Operates only the voice channel with one digital transceiver
• Digital DW ................................Operates the voice channel and preset search channel by dual-watching with one transceiver
• Digital Double ...........................Uses one transceiver for the voice channel and a second transceiver for the preset search
• Analog ......................................Operates only the voice channel with an analog transceiver
Voice CH
The voice channel operating information can be set.
Modulation ..................................Displays "Digital" or "Analog" depending on the "Operation mode" setting.
Frequency ...................................Enter the frequency in units of MHz.
SQL code ....................................Enter the SQL information. The selectable value differs depending on the "Modulation" setting.
<For an analog operation>
NoTone ................................Does not use any tone types of SQL such as CTCSS and DCS
ToneSQL ..............................Uses the CTCSS tone SQL function
DCS ..................................... Uses the DCS code SQL function
FM Narrow Deviation ...........Select this option when the radio wave type is narrow-band FM.
<For a digital operation>
"DSQ" will appear and OFF or a code from 001 to 126 can be selected.
Power .........................................Set the transmission output of the transceiver used for the voice channel.
Offset ..........................................Enter the offset value for "Frequency" in units of MHz.
Reverse ......................................Put a check-mark to transmit at the operating frequency and receive at the offset frequency
Hide frequency settings ..............Put a check-mark to temporarily hide your node operating information from the node list on the
How to Use
Tip Dual Watch Timing setting: The interval time to switch monitoring between the voice channel and preset
search channel can be set from 1 second to 15 seconds in 1 second increments. Normally, set it to 1
second.
Caution When operating in GM mode, this mode cannot be selected.
channel
Caution When operating in GM mode, this mode cannot be selected.
Caution When operating in GM mode, this mode cannot be selected.
Selecting this option allows you to select the tone frequency from 67.0Hz to 254.1Hz.
Selecting this option allows you to select the code from 023 to 754.
Tip The setting is valid only with a transceiver compatible with the HRI-200 control mode.
Tip If your transceiver supports the HRI-200 control mode, the information will also be reflected automatically
into the transceiver.
(the default value).
Remove the check-mark to receive at the operating frequency and transmit at the offset
frequency (Normally, the setting is the same as the mobile transceiver).
Tips • The setting is valid only with a transceiver compatible with the HRI-200 control mode.
• For a repeater operation, put a check-mark since the transmitting/receiving relationship is opposite to a
mobile transceiver.
WIRES-X server.
Basic Operations
24