Yaesu WIRES-X HRI-200 Instruction Manual page 14

5
Confirm the destination where the WIRES-X software will install
and click [Next]
The "Ready to install WIRES-X" window will appear.
Tip If you put a check-mark in the "Enable WIRES-X Auto Start." check
box, the WIRES-X software will run automatically when Windows
starts.
Even when the WIRES-X software is terminated for some reason, it
will reboot automatically.
6
Click [Install]
Program installation will start.
Tips • To confirm or change the installation setting, click [Back].
• To exit the wizard, click [Cancel].
When installation completes, the "Completed the WIRES-X
Setup Wizard" window will appear.
7
Click [Finish]
The "Completed the WIRES-X Setup Wizard" window will close.
When WIRES-X software installation has been completed
properly, the [Wires-X] icon will appear on the Windows
desktop.
8
Click [Close] in the "WIRES-X installer" window
Preparation
Installing WIRES-X Software
14