Yaesu WIRES-X HRI-200 Instruction Manual page 79

RX Filter ......................................Inserting a check-mark passes received sound into the filter circuit. Normally, keep this
Audio Mute SW (SQL) ................Inserting a check-mark synchronizes the ON/OFF switch of the received audio input circuit
MIC BOOST (MAMP) .................Inserting a check-mark inserts an amplifier circuit into the received audio input circuit.
Pre-emphasis .............................Inserting a check-mark passes transmitted sound into the pre-emphasis circuit. Normally, keep
Tx Filter .......................................Inserting a check-mark passes transmitted sound into the filter circuit. Normally, keep this
DTMF
Allows you to set the DTMF circuit detecting operations of CH1 (voice channel).
Mute mode ..................................When sound contains a DTMF signal, set the functional operation to mute analog sound while
DTMF detect Gain ......................Set the input gain of the HRI-200 built-in DTMF decoder circuit signal (Low/High). Normally,
DTMF Call cansel
Set the DTMF signal to be imported by HRI-200.
Signals of selected buttons will be detected. Signals of unselected buttons will be ignored.
Clicking [Write] displays "" for the selected buttons, and "" for the unselected buttons.
Normally, keep all the DTMF signals selected "" (default setting).
[HRI-200 Information] .................Click to read out and display the value set on EEPROM of HRI-200.
[Write] .........................................Click to write each configured settings on EEPROM of HRI-200.
Caution
Settings configured on the "HRI-200 setup" screen are reflected on HRI-200 by clicking [Write].
WIRES-X Software
function unchecked (default setting).
Caution
Communications between digital stations are not affected by this setting.
with the SQL jack signal. Normally, keep this function unchecked (default setting). Normally,
keep this function unchecked (default setting).
Normally, keep this function unchecked (default setting). Normally, keep this function
unchecked (default setting).
Tip This function is effective for an analog operation when the received audio input level from the FM analog
transceiver is extremely low, however, using this function may cause sound distortion. Use the functions
such as the waveform monitor function to prevent the input sound from distorting by adjusting the volume.
Caution Communications between digital stations are not affected by this setting.
this function unchecked (default setting).
Caution Communications between digital stations are not affected by this setting.
function unchecked (default setting).
Caution Communications between digital stations are not affected by this setting.
detecting the DTMF signal.
OFF .................Repeating is continued even when the DTMF signal is detected (default
setting).
Audio mute ......While detecting the DTMF signal, mute analog sound and repeat (only the
transmitting state (PTT control) will be maintained).
Caution
Communications between digital stations are not affected by this setting.
set it to Low (default setting).
EEPROM of HRI-200. When writing successfully, the written out value will be read out again
and displayed on the screen.
Main Menu
79