Removing The Electronic Control Board - Maytag MED / GD 9700S Technical Education

REMOVING THE ELECTRONIC CONTROL BOARD

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug dryer or disconnect power.
2. Turn off gas supply to dryer.
3. Pull the dryer away from the wall far
enough to access the back.
4. Remove the three hex-head screws from
the rear flange of the dryer's top cover.
NOTE: The top cover screws have nylon
flat washers on them. Be sure to use these
screws when you reinstall the top cover.
Top Cover Rear Flange Screws
W/Nylon Flat Washers
5. Lift the rear of the top cover and slide it
back so the tabs clear the catches on the
bracket, and remove the cover from the
unit. NOTE: Make sure that the tabs slide
under the bracket catches when you rein-
stall the top cover.
Cover Flange Tab
Slide Top Cover Back
6. Remove the three screws from the elec-
tronic control board bracket and pull the
bracket away from the side of the dryer so
you can access the connectors.
Electronic Control Board Bracket
Screws
7. Disconnect the 3-wire connector from the
main harness.
4-2
Under Bracket Catch