Adjusting The Lens And Image; Zoom; Focus; Shift - Digital Projection Titan 800 3D series User Manual

Digital Projection
Titan 800 3D series

Adjusting the Lens and Image

Zoom

•
Press followed by and
•
When the adjustment is finished, press

Focus

•
Press followed by and
•
When the adjustment is finished, press

Shift

•
Press followed by ,
•
When the adjustment is finished, press

Picture

•
You can set Brightness , Contrast

Switching the Projector Off

•
Press on the remote control or the control panel, and hold for 3 seconds, to switch the projector OFF. The power indicator on the
control panel will show amber, the lamp will be off and the projector will be in STANDBY mode.
•
Switch off at the switch next to the power connector. Disconnect the power cable from the projector.
Rev A June 2012
to adjust the size of the image on the screen.
.
to adjust the focus.
.
, and to adjust the position of the image on the screen.
.
or Saturation by pressing ,
OPERATING THE PROJECTOR
or on the remote control.
Installation and Quick-Start Guide
Notes
When any of the three Lens
adjustment keys is pressed, the blue
Transmit indicator on the remote
control will light for 10 seconds:
- after 10 seconds, if no adjustment
has been made, the indicator will
go out and the Lens adjustment key
must be pressed again to resume
adjustment.
- to end the adjustment before 10
seconds has elapsed, press the
key.
- all other adjustments will be locked
out until the Lens adjustment is
ended.
You can use the projector menus to
access image and lens settings. For
full details of how to use the controls
and the menu system, see the
Operating Guide.
Always allow the lamp to cool for
5 minutes before:
- disconnecting the power
- moving the projector
Page Inst_7