Selecting A Test Pattern; Adjusting The Lens; Adjusting The Image - Digital Projection E-Vision Laser 8500 Series Important Information Manual

Digital Projection E-Vision Laser 7500 & 8500 Series

Selecting a test pattern

To display a test pattern:
•
Press on the remote control. If necessary, press again to change the test pattern. Test
TEST
patterns are displayed in the following order:
White, Black, Red, Green, Blue, CheckerBoard, CrossHatch, V Burst, H Burst, ColorBar, Off
After the final test pattern, the projector exits test pattern mode and returns to the main image. To
view test patterns again, you need to press
•
Alternatively, open the OSD by pressing
then select a test pattern using the

Adjusting the lens

The lens can be adjusted using the
Lens menu
The menu provides access to the
Lens
allows
Lens Control
operates in
Zoom/Focus Adjustment
Press ENTER/SELECT to switch between the two modes.
Remote control
Use the remote control to adjust zoom, focus and shift directly, without opening a menu:
•
enters lens control, then switches between
OK
•
exits lens control and opens the
EXIT
•
exits lens control and returns to the main image.
MENU
•
The arrow buttons adjust zoom, focus and shift as indicated on the screen.

Adjusting the image

Orientation
•
This can be set from the
Highlight Projector Mode and choose from
.
Rear Ceiling
Keystone
•
This can be set from the
Picture
•
Settings such as
from the
Image
Rev D January 2017
LEFT
Lens
Lens Control
, and
Zoom Focus Shift
and
menu.
Setup
Geometry
,
Gamma Brightness, Contrast
menu.
again.
TEST
. Highlight
MENU
and arrow buttons.
RIGHT
menu, or using the lens buttons on the remote control.
setting and the
adjustment using the arrow buttons. The setting
Shift Adjustment
Zoom/Focus Adjustment
menu.
Lens
Front Tabletop
menu.
,
Saturation
Important Information
from the main menu,
Test Patterns
Lens Center
mode.
and
, ,
Front Ceiling Rear Tabletop
, and
Hue Sharpness
command.
.
Shift Adjustment
and
can be set
Page 15