Dmx Mode; Set The Dmx Starting Address; Dmx Mode Selection; Slave Mode - Blizzard Lighting BladeRunner RGBW User Manual

DMX Mode

Allows the unit to be controlled by any universal DMX controller.

Set The DMX Starting Address

To assign a DMX staring address to the fixture, use the <MENU> button to scroll to Address,
then use the <UP/DOWN> buttons to display any value within the range of 001-512. Then
push the <ENTER> button to confirm your choice.

DMX Mode Selection

To use the fixture in either of its two DMX channel mode configurations, use the <MENU>
button to scroll to CHND, then use the <UP/DOWN> buttons to display either 14CH or 32CH.
Then push the <ENTER> button to confirm your choice.

Slave Mode

1.) Disconnect fixture(s) from any DMX signal source.
2.) Set each fixture to matching DMX modes (14CH or 32CH).
3.) Connect all fixtures together via DMX. The first fixture in the DMX chain will be the master
fixture, followed by the slave fixtures.
4.) Connect DMX controller to the master unit for DMX control.

Stand-Alone, Master/Slave, Sound Active Modes:

Allows a single or Master/Slaved units to run factory installed programs at user selectable speeds.

PRO-Movement

This allows you to enable/disable auto movement of the heads in Program Mode or within Manual
Color Adjustments. This will not effect movement in Auto or DMX modes.
1.) Use the <MENU> button to scroll to PRO-Movement, then use the <UP/DOWN> buttons
to display either ON or OFF. Then push the <ENTER> button to confirm your choice.

Speed Settings

This allows you to adjust the speed of the moving heads and color macros in Program Mode, Auto
Mode or within Manual Color mixing. This will not effect speed in DMX mode.
1.) Use the <MENU> button to scroll to SPEED, then use the <UP/DOWN> buttons to display
either Movement or Color, then push the <ENTER> button. You can now adjust the speed
settings from 001-255 (slow <--> fast).

Auto Mode

To run the fixture in auto mode, use the <MENU> button to scroll to AUTO or AUTO 1, then
push the <ENTER> button to confirm. You then adjust the movement and color macro speed
settings of the auto mode program (see Speed Settings).

Sound Active Mode

To run the fixture in sound active mode, use the <MENU> button to scroll to AUDIO, then push
the <ENTER> button to confirm.
BladeRunner™ RGBW User Manual Rev. A
Page 12
(c) Copyright 2014 Blizzard Lighting, LLC