Fixture Linking (Master/Slave Mode); Mounting/Rigging; Lighting Stand Mounting - Blizzard Lighting BladeRunner RGBW User Manual

Fixture Linking (Master/Slave Mode)

1. Connect the (male) 3 pin connector side of the DMX cable to the output
(female) 3 pin connector of the first fixture.
2. Connect the end of the cable coming from the first fixture which will have a
(female) 3 pin connector to the input connector of the next fixture consisting of
a (male) 3 pin connector. Then, proceed to connect from the output as stated
above to the input of the following fixture and so on.
A quick note: Often, the setup for Master-Slave and Standalone operation
Mounting & Rigging
This fixture may be mounted in any SAFE position provided there is enough
room for ventilation.
It is important never to obstruct the fan or vents pathway. Mount the fixture
using a suitable "C" or "O" type clamp. The clamp should be rated to hold at
least 10x the fixture's weight to ensure structural stability. Do not mount to
surfaces with unknown strength, and ensure properly "rated" rigging is used
when mounting fixtures overhead.
Adjust the angle of the fixture by loosening both knobs and tilting the fixture.
After finding the desired position, retighten both knobs.
• When selecting installation location, take into consideration lamp
replacement access (if applicable) and routine maintenance.
• Safety cables MUST ALWAYS be used.
• Never mount in places where the fixture will be exposed to rain, high
humidity, extreme temperature changes or restricted ventilation.

Lighting Stand Mounting

This fixture comes with an easy to use stand mounting bracket. Please make
sure the lighting stand you use is rated to safely hold the weight of this unit and
do not over-extend the lighting stand. For the safety of yourself, your audience,
and the fixture... always take advantage of the use of the stand's safety pins!
BladeRunner™ RGBW User Manual Rev. A
requires that the first fixture in the
chain be initialized for this purpose
via either settings in the control
panel or DIP-switches. Secondarily,
the fixtures that follow may also
require a slave setting.
Check the "Operating
Adjustments" section in this
manual for complete instructions
for this type of setup and
configuration.
Page 10
(c) Copyright 2014 Blizzard Lighting, LLC