Table of Contents
Advertisement
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
Starting DMX Address
1.) Navigate the main menu until you reach DMX, and press the
<ENTER> button.
2.) Then highlight Address, and press <ENTER>.
3.) Use the <UP/DOWN> buttons to select a starting DMX address
ranging from 1-512, and press the <ENTER> button to confirm.
DMX Channel Mode
1.) Navigate the main menu until you reach DMX, and press the
<ENTER> button.
2.) Then highlight Channel Mode, and press <ENTER>.
3.) Use the <UP/DOWN> buttons to select 4-channel, 6-channel, or
9-channel, and press the <ENTER> button to confirm.
M/S Mode
1.) Daisy chain the DMX input/output connections of the fixtures.
2.) On the 1st fixture, navigate to System and press <ENTER>.
3.) Use the <UP/DOWN> buttons to highlight Host Mode, and then
press <ENTER>. Then highlight ON, and press <ENTER>.
4.) On following fixtures, verify that this setting is set to OFF.
5.) If the DMX signal is lost while operating, it will default to the set
Auto Mode, or Manual Mode (Manual Mode if Auto is set to Stop).
Auto Mode & Manual Adjustments
Allows a single or daisy chained units to run factory installed programs.
Auto Mode
1.) Navigate the main menu until you reach Auto, and press the
<ENTER> button.
2.) Use the <UP/DOWN> buttons to highlight Run Mode, and press
the <ENTER> button.
3.) Use the <UP/DOWN> buttons to highlight Flash, Fade, or Pulse,
and press the <ENTER> button.
4.) To stop an auto program, use the <UP/DOWN> buttons to
highlight Stop, and press <ENTER>.
5.) To adjust the auto speed, highlight Speed and press <ENTER>.
6.) Now you can adjust the speed from 0-255 (slow <-> fast).
Manual Mode
1.) Navigate to Manual, and press <ENTER>.
2.) Use the <UP/DOWN> buttons to highlight Dimmer, Strobe, Red,
Green, Blue, or White, and press <ENTER>.
3.) Adjust the levels from 0-255, and press the <ENTER> button.
Motif™ Metro User Manual Rev. A
Page 12
© 2020 Blizzard Lighting, LLC
Advertisement
Table of Contents
