Additional User Adjustments; Service Functions; Resetting The Fixture; Restoring Factory Defaults - Blizzard Lighting ICE 30 User Manual

Additional User Adjustments

To restore all settings to their factory defaults:
1) Use the "Load Data" function in the menu (see page 12).
Operation
Master/Slave Mode (Master Sound, Master Auto):
This mode will allow you to link up to 32 units together without a controller.
1) Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of
the units. For longer cable runs we suggest a terminator at the last fixture.
2) Choose a unit to function as the Master. Turn dipswitches to the Master position on the unit. The
unit must be the first unit in line. Then simply chain the units together using DMX cable.
Note: The master unit must be in one of the Auto or Sound modes. See the Menu Map for setting
the options in the menu and navigating the Control Board.
3) Adjust the "Operation" to "Slave" on the slave units, and they will react the same as the Master
unit.
Note: if you would like to have the fixtures inverted, this can be set in the Control board.

DMX Mode

This mode allows the unit to be controlled by any universal DMX controller. If you are unfamiliar
with DMX, please read the DMX Primer section.
1) Set the menu to "Address."
2) Set your DMX starting address, and hit <ENTER> to confirm.
DMX Channel Values
The ICE 30™ has 2 DMX channel profiles (operation modes). These can be accessed in the Control
Board.

Gobo Replacement

1) Remove the gobo cover by removing the two screws on the top of the fixture head.
2) Remove the slot-n-lock gobo from the gobo wheel by lifting up slightly and sliding it out.
3) Using a small tool, pry the tension ring from the gobo holder.
4) Remove the old gobo.
5) Insert the new gobo, and replace in the reverse steps of removal.
Page 13
ICE 30 Manual Rev. C Copyright (c) 2012 Blizzard Lighting, LLC