DMX Mode
Allows the unit to be controlled by any universal DMX controller.
Select the Channel Mode
1.) Press <MENU> to enter EDIT interface.
2.) Use the <UP/DOWN> buttons to choose Operate Mode, press <ENTER>.
3.) Use the <UP/DOWN> buttons to highlight 15 Channel or 37 Channel.
4.) Press the <ENTER> to confirm, or <MENU> to exit.
Select the Starting DMX Address
1.) Press <MENU> to enter EDIT interface.
2.) Use the <UP/DOWN> buttons to choose DMX Address, press <ENTER>.
3.) Use the <UP/DOWN> buttons to choose a starting DMX address ranging from
001-512, press <ENTER> to confirm, or <MENU> to exit.
Master/Slave Mode Settings
1.) Connect fixtures together via DMX.
2.) Press <MENU> to enter EDIT interface.
3.) Use the <UP/DOWN> buttons to choose Operate Mode, press <ENTER>.
4.) Use the <UP/DOWN> buttons to choose Mast Mode, press <ENTER>.
5.) From here you can choose to set each fixture to act as either the master (first
in DMX chain), or a slave which will follow the master.
6.) Press <ENTER> to confirm your choice.
Auto and Sound Active Modes:
*Important:
To use Auto or Sound Active modes in Standalone, the settings in DMX
Lost must also be set to match: Auto or Sound Active. Press <MENU>, go to <System
Settings>, navigate to <DMX Lost>, select <Auto> or <Sound> and save. Then...
Auto Mode
1.) Press <MENU> to enter EDIT interface.
2.) Use the <UP/DOWN> buttons to choose Operate Mode, press <ENTER>.
3.) Use the <UP/DOWN> buttons to choose Auto Mode, press <ENTER>.
4.) Use the <UP/DOWN> buttons to choose a built-in program, press <ENTER>.
Sound Active Mode
1.) Press <MENU> to enter EDIT interface.
2.) Use the <UP/DOWN> buttons to choose Operate Mode, press <ENTER>.
3.) Use the <UP/DOWN> buttons to choose Sound Control, press <ENTER>.
4.) Use the <UP/DOWN> buttons to choose the microphone sensitivity level
ranging from 0% to 99%, press <ENTER>.
Snake Eyes™ Manual Rev. A
Page 14
© 2016 Blizzard Lighting, LLC