ClearOne Beamforming Microphone Array Installation Manual page 20

Slide the Suspension Column up or down adjusting it so the Beamforming Microphone Array will
be placed approximately 8 feet above the floor.
Fully tighten the screws on the position clamps. Attach and tighten a Locking Plate on to each
Position Clamp to secure the assembly to the Support Rails.
Pass the E-bus cables for LINK IN and LINK OUT (if needed), and the PoE cable from above the
ceiling through the pass-through hole down the Suspension Column and out of the assembly.
E-bus Cables for
LINK IN and LINK OUT
Connections
PoE Cable
Prepare the Beamforming Microphone Array for attachment to the Suspension Column by partially
inserting the screws. There are three slotted keyholes big enough for screw heads to pass through
and one hole that is not slotted. Partially insert screws into the Beamforming Microphone Array
corresponding to the slotted keyholes in the Mic Mounting Plate.
16 Beamforming Microphone Array
E-bus Cables for
LINK IN and LINK OUT
Connections
HC 2X
2X
G
PoE Cable
(Ceiling tile and front
supports not shown.)