ClearOne WS800 Quick Start Manual
  1. Manuals
  2. Brands
  3. ClearOne Manuals
  4. Microphone system
  5. WS800
  6. Quick start manual

ClearOne WS800 Quick Start Manual

Wireless microphone system
Hide thumbs Also See for WS800:
Table of Contents

Advertisement

Quick Links

See also: User Manual , Quick Start Manual

Quick Start Guide

WS800 Wireless Microphone System
Quick Start Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WS800 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for ClearOne WS800

Summary of Contents for ClearOne WS800

  • Page 1: Quick Start Guide

    Quick Start Guide WS800 Wireless Microphone System Quick Start Guide...

  • Page 2: Antenna Design

    System Test: In most cases, the system is now ready to use. Confirm all channels pass audio perfectly. Modifications (FCC 15.21) Changes or modifications to this equipment not expressly approved by ClearOne may void the user’s authority to operate this equipment.
  • Page 3 Default = Balanced line output. 3. Ethernet Settings: If using Ethernet, assign the proper IP address to the ClearOne Receiver. 4. RF Scan - RF Plot: Shows the RF strength of each antenna in a ClearOne system and shows if there is outside interference.

  • Page 4: How To Sync Transmitters With The Receiver

    How to sync transmitters with the receiver: How to sync transmitters with the receiver: 1. Locate the IR (infrared) Sensor on the transmitter. ON / OFF ON/OFF 2. Power on the transmitter. 3. Hold transmitter about 6 inches from the corresponding receiver module with the IR sensor aimed at the receiver module.

  • Page 5: Front Pannel

    2. Receiver Module. See details below 3. Mixed audio volume control. 4. USB Port. Connect to computer for ClearOne Remote control. Run software to monitor/edit system parameters, scan for RF interference and download firmware upgrades. 5. Mixed audio output, 1/4” (See headphone mode - Pg. 3) phone jack for monitoring individual channels or mixed channels.
  • Page 6 RS232, use a straight DB25 to DB25 cable. Do not use a null modem cable. GPIO: GPIO acts like a contact closure. Use ClearOne Remote to assign an event that toggles the GPIO pin. The factory default toggles pins X through X to correspond to muting a receiver module. ClearOne...
  • Page 7 2. Programmable Switch: Toggle on/off, on/mute/ or on/on. 3. Microphone Connector: TA4 mini XLR style: ClearOne offers a full range of lavaliere and headset mics for optimal performance of your ClearOne transmitter. Works with both snap in and screw-in microphones.

  • Page 8: Podium Gooseneck Stem

    Transmitters: CONFERENCE TABLE-TOP: The ClearOne DS80-C Conference Table-top Mic combines the professional audio specs and security of a wired mic with wireless convenience. Available in omni or cardioid polar pick-up patterns with 265-bit FIPS 197 encryption. 1. Power LED: When the Table Mic is on, the LED signals:...

  • Page 9: Podium Gooseneck

    Sales: 800-707-6994 Other product names may be registered trademarks of their respective owners who do not necessarily endorse ClearOne or ClearOne’s products. All rights reserved. Information in Fax: 801-977-0087 this document subject to change without notice. © 2012 ClearOne. QSG-0007-001 Revision 1.0 December 2012.

Table of Contents